Safety measures to take on equipment..

When I set up a low water cut off on a Honda twin cylinder, I use a black wire with a yellow stripe. It's the fuel solenoid circuit.
GX690 wiring.jpg
 
Thanks Russ!

I'll try to install it when we get above freezing temperatures. I got the bulkhead type from madison.
 
Even though this is an older thread, It can't be stressed enough, Keep all of your safety equipment in good operating condition. If you have a high temp, or pressure relief valve go bad while on the job, You are done for the day. Never alter or modify either... You could end up with a boiler explosion.

Most of the time, Pressure relief and high temp safety valves reset with no problems...

Mike
 
Back
Top