Chris Tharpe
New member
I have a brand new small engine that was recieved about a month ago, I installed it on my reclaim unit and I am having problems getting it to run without full choke.
18hp briggs, The fuel tank is about 4-5 ft below the machine so I have installed a boat primer bulb to prime the engine just to keep from turning it over constantly trying to re-prime the fuel system. The first day this was installed I let it run for a few minutes and all was good as far as I can remember but now it will only run with the choke on full. I have pulled the carb, cleaned it out good and still the same issue. Any ideas, the engine has less than 30minutes run time on it
18hp briggs, The fuel tank is about 4-5 ft below the machine so I have installed a boat primer bulb to prime the engine just to keep from turning it over constantly trying to re-prime the fuel system. The first day this was installed I let it run for a few minutes and all was good as far as I can remember but now it will only run with the choke on full. I have pulled the carb, cleaned it out good and still the same issue. Any ideas, the engine has less than 30minutes run time on it