Your DReam RIG, what would it have on it?

I want a 40 foot gooseneck stacked high with one hundred dollar bills from front to back.

I'm with Russ, that would be the best setup ever, that is unless you had 2 40' goosenecks stacked high
 
I'd like a flatbed setup with

One 8gpm all electric hot water unit
Plus
Two separate electric 8gpm cold water units that I can tie together for 24 gpm if needed
With
3 electric reels that can hold 600 ft each of 3/8 hose.

And I'd like all that to run off a generator that is run by a pulley on the truck motor.

I'd like a 1000 gallons of water onboard.

And all this on an F350.

Can somebody get to work on that for me? Paul? Jerry? Russ? lol
 
ok on a serious note

16 foot flatbed Isuzu crew cab with 2 10 gpm hot water rigs, (6) 18 inch stainless reels, 4 for high pressure and 2 for filler hose, two 225 gallon tanks, one for fresh water and the other for roof cleaning plus (2) 55 gallon tanks for chems, split 8 foot under body boxes on both sides and a ladder rack for various ladders, air compressor and a 3/4 in air diaphragm pump and an additional 18 in stainless reel with chem hose.
 
Basicly the same type of setup as you russ but smaller sized equipment. you do way more work then me so i dont need what you need.

16 foot isuzu,iveco or mitsubishi 2 8 gpm hot water tied together ,and if possible split one for 4 and 4gpms 4 stainless reels 2 for high pressure 1 for water and 1 for chemical all with 200 feet of each. 1 225 gallon water 1 100 gallon and 1 60 gallon. pump set up to do either roofs or anything else. ladder racks. 5 gallon bucket holders surface cleaners and a spot to put them. tool boxes. and a ladder built in to get my fat azz up on the truck.
 
How about 4 really hard working, loyal, dedicated employees.
 
My Dream Rig

Well it would be something like this....
7x20 trailer
(2)-6gal 4000psi hot water units on front tied together so I can run Hot 12gal @ 4,000 psi or run separately.
(2) 11gal 2300psi cold water units on each side of back of trailer
(2)-525 black poly tanks,
(4) electric cox hose reels, 2 facing the rear and one on each side
Lockable ladder racks on top
racks for 2 55's drums on each side of trailer.
All hose reels are valved and set up so I can switch and run any combination of pressure washer to any real.
Tail gate was actually the ramps that came with trailer, they are hinged on corners and open from the center.
2 stainless steel gas tanks 18 gal each....one for the the front two units and one for the back two units.

We rolled it out of shop today and these are the first pictures outside of the shop.
 

Attachments

  • DSC_0542 (2).jpg
    DSC_0542 (2).jpg
    262.6 KB · Views: 118
  • DSC_0544 (2).jpg
    DSC_0544 (2).jpg
    266.4 KB · Views: 109
Well it would be something like this....
7x20 trailer
(2)-6gal 4000psi hot water units on front tied together so I can run Hot 12gal @ 4,000 psi or run separately.
(2) 11gal 2300psi cold water units on each side of back of trailer
(2)-525 black poly tanks,
(4) electric cox hose reels, 2 facing the rear and one on each side
Lockable ladder racks on top
racks for 2 55's drums on each side of trailer.
All hose reels are valved and set up so I can switch and run any combination of pressure washer to any real.
Tail gate was actually the ramps that came with trailer, they are hinged on corners and open from the center.
2 stainless steel gas tanks 18 gal each....one for the the front two units and one for the back two units.

We rolled it out of shop today and these are the first pictures outside of the shop.

Very nice rig Al
 
That is one hell of a rig. I hope that I would need something like that some day. As for now I just want something that doesnt burn any fuel and always runs without breakdowns.
 
Well it would be something like this....
7x20 trailer
(2)-6gal 4000psi hot water units on front tied together so I can run Hot 12gal @ 4,000 psi or run separately.
(2) 11gal 2300psi cold water units on each side of back of trailer
(2)-525 black poly tanks,
(4) electric cox hose reels, 2 facing the rear and one on each side
Lockable ladder racks on top
racks for 2 55's drums on each side of trailer.
All hose reels are valved and set up so I can switch and run any combination of pressure washer to any real.
Tail gate was actually the ramps that came with trailer, they are hinged on corners and open from the center.
2 stainless steel gas tanks 18 gal each....one for the the front two units and one for the back two units.

We rolled it out of shop today and these are the first pictures outside of the shop.

Sweet rig Al! Those are big burners on the front, are they custom or from a particular manufacturer?
 
Back
Top