Wood Restorer Sale

BWilson

New member
Inventory Reduction Sale $45 plus shipping
Wood Restorer 40




As the effects of the environment begin to break down the wood fibers restoration becomes necessary. The typical process is to clean/strip, neutralize and seal the wood. Each step is important and if not done properly the sealer will fail prematurely.
When used as directed Wood Restorer will stop the degeneration of the wood and bring it back to its natural state. The special blend of high grade surfactants and oxygenators will lift and disperse the damaged wood fibers while killing and removing the mildew that is feeding on your wood. In addition Wood Restorer opens up the pores of the wood to allow for better acceptance of the sealer. Wood Restorer is an excellent product for cleaning as well as the removal of light and failing sealers.
For best results mix approximately 1/2 -1 of a pound of the product in approximately 2-3 gallons of warm water and apply to the surface with a sprayer. Allow the product to stand for approximately 15-20 minutes and rinse with low pressure, 1500 psi or less is all that is necessary to do the job.
It is recommended that you use a Shurflo or Flojet pump to apply the product as it produces oxygen as it exhausts itself. If used in a sealed container it may over pressurize the vessel and damage the seals or the container itself. If used in an enclosed container be sure to remove the top when not in use so the gases can escape. Do not mix up more than you can use within an hour or less as the product will exhaust itself over time.
 
Back
Top