Roof cleaning setup I built

wbrett1027

New member
Finally pulling the trigger, in getting started with roof cleaning, this is the the roof cleaning skid I just built, it consist of a 55 gallon chemical tank, 60 psi, 7gpm.. 300ft of chemical hose, I will be using a deep cycle marine battery
All Tig welded

ImageUploadedByTapatalk1429112828.504495.jpg
ImageUploadedByTapatalk1429112842.443388.jpg
ImageUploadedByTapatalk1429112855.587163.jpg


Sent from my iPhone using Tapatalk
 
Pick your self another tank for chemical.
55 gallon is not going to do it.
 
Where is the fresh water tank?

You don't want to connect the garden hose to 12 volt pumps for rinsing or rinsing them out, it will mess them up.
 
Where is the fresh water tank?

You don't want to connect the garden hose to 12 volt pumps for rinsing or rinsing them out, it will mess them up.

I haven't added it yet, but there will be a hose attachment with a valve so I can flush the system after each use


Sent from my iPhone using Tapatalk
 
I haven't added it yet, but there will be a hose attachment with a valve so I can flush the system after each use


Sent from my iPhone using Tapatalk

Agreed. I wouldn't pressurize the inlet of the pump with anything more than hooking up to a tank. If you need to just drop your suction line into a 5 gallon bucket of clean water. I always run about 15 gallons through mine at the end of the day.


Sent from my iPhone using Tapatalk
 
I do the same thing Hal,..I have my roof pump tied into my pressure wash tank and just turn the SH off and the fresh water on,...flush whole system with enough water back into the mix tank to make the next batch. SH is VERY slippery,..and just a quick flush doesn't do it adequately.

Jeff
 
Nice work....
 
Great Job!

AC
 
Back
Top