Burner Help

Jeff O

New member
I have a relatively new unit where the burner stopped working. It's a Beckett ADC 12v. The fuse blew which we replaced; however it won't fire up. The red on light just blinks. It's almost as though it needs reset, but this model doesn't have a reset button. Any thoughts?

Jeff
 
There is a very specific "Procedure" for troubleshooting a Diesel Burner..
..and it goes aLot faster with a fuel Pressure Gauge, clear (nylon Braid) fuel lines,
..and me on the phone..
"Relatively New" just means you haven't adjusted the electrodes yet,
..and you also haven't experimented with the Air-Bands yet.. and you Need to.
If you want Training, and Troubleshooting in one sitting, call me for an appointment, and we'll get'er Done.
check my Technical page, and call me.
https://pressurewasher.net/pages/technical-information-working-copy
Before you call.. check the BatteryVoltage With the burner ON,
makeSure ALL electrical connections are Corrosion Free !
 
Meant to update this sooner. Turns out the blower motor had locked up. Had fewer than 500 hours on it, but the issue is resolved!
 
Back
Top