I would like to see pics of tank set-ups

planethopper

New member
Does anyone out there have some good pics of thier tank plumbing. I'm seting up my system in my cube van and I want access just from the side door and boxing it in from the back because I use the truck for rubbish removal to and I don't want garbage hitting my equipment. I have to fill my tanks and use my equipment all from the side door that I still have to cut into the side of the truck. I have two 125gal tanks and a dynablast H4035. Any pics and ideas?
 
Here are some pic's of the back of our White truck and piping.

Hope you get some ideas.

Dave Olson
 

Attachments

  • White truck pics for John 6 sml.jpg
    White truck pics for John 6 sml.jpg
    47.7 KB · Views: 224
  • White truck pics for John 7 sml.jpg
    White truck pics for John 7 sml.jpg
    27.6 KB · Views: 194
  • back of white[1].jpg
    back of white[1].jpg
    58.4 KB · Views: 300
Truck set up pictures

Sorry, I could not find any pictures of my tank setup. I always have access to my customers water so theres no need for a large holding tank.
The truck has a 55 gallon tank as a buffer with bypass, It is equipped with a float valve and the truck has external water inlet that makes hooking up to my customer water supply much easier.

The 15 gallon gravity flow tank mounted above is for antifreeze to make winter operations possible, the box is insaulated and always heated during the winter months by a forced air propane furnace, with thermostat control and auto paging if trucks box falls below 50 degress. Box is air conditioned by carrier unit as well.
 

Attachments

  • Work Truck Pics 0011.JPG
    Work Truck Pics 0011.JPG
    82.4 KB · Views: 93
  • Work Truck Pics 010.jpg
    Work Truck Pics 010.jpg
    53 KB · Views: 193
  • Work Truck Pics 0131.JPG
    Work Truck Pics 0131.JPG
    80.2 KB · Views: 224
Here are some pics of a dual tank set up. The feed comes from the left, and can fill either tank. Both have hudson float valves inside.
The hose going to the right plumbs the small float tank, so I can keep both tanks empty or use them for recovery, while running off the small tank.

The other pic shows the valves up front to pick a tank. The tansk also have a ball valve underneath so that they can level themselves out.
 
Last edited:
Pressure Washer Products Tank and Filters

These pics are of an install that we did last weekend.
 

Attachments

  • roof_cleaning_equipmentDSCF4860.jpg
    roof_cleaning_equipmentDSCF4860.jpg
    70.8 KB · Views: 74
  • roof_cleaning_equipmentDSCF4871.jpg
    roof_cleaning_equipmentDSCF4871.jpg
    149.9 KB · Views: 64
  • roof_cleaning_equipmentDSCF4844.jpg
    roof_cleaning_equipmentDSCF4844.jpg
    60.8 KB · Views: 71
Back
Top