Micro-Rigs roof cleaning

Apple Roof Cleaning

Roof Cleaning Instructor
Chris I dont even run a roof cleaning setup at the moment , I have put it on hold, our commercial business is doing so well I dont have the time to even mess with it, I have Titan reels , 5/8 hoses, ploy guns, 225 gallon, ect..... leg tanks all in the garage along with my dewalt air compressor I bought to clean roofs with, all I am lacking is the pump , I figure I will get it all set up sometime in October , we are going to run it out of a 1 ton extended van. I will take some pics when we get her done , oh and we are going to do a wrap on the van as well , tint windows ect !
COOL !
I KNOW you have been busy Big Guy :)
The DeWalt is a real nice compressor.
The Wrap will be nice too.

A Rolling Billboard, plus chemical protection for the Van.

Make SURE that puppy is vented ?
Fumes can spoil yer day :eek:
 

Ron Musgraves

Exterior Restoration Specialist
Staff member
Actually Like that
Its the wave of the future. 27+ mpg is the best.


 

LincolnS

New member
So here I am on a small budget, gotta pay the bills you know! The van was killing me on gas 20 to 50 a day on gas. I guess I have it better than most with that kind of gas bill, but still killing me! I decided to go with a small trailer to put my equipment on to be towed with a smaller V-6 engine! The van is now for sale! Its small but Im already loving this thing! Its all a roofer needs and then some! Kinda reminds me of the Hotwheels Micro Machines in the 80's! I'll do signs next week!
Are they experienced one you visited?
 

luisbogdani

New member
With 16 mm and 25 mm fascias, there is no need to use a support board. The gutter or eaves are then attached directly to the soffit and fascia. The cladding of your home is also essential for another reason, and that is purely aesthetic. These are vertical boards that are directly under the roof, so they are apparent. Over time, cladding boards tend to become weathered and therefore discolored, and they should be serviced annually, including painting if they are made of wood or just cleaning if they are made of vinyl or metal. During this annual maintenance, the cladding should also be checked for rot or damage to support the gutters or eaves.
 
Last edited:

milolieng

New member
With 16 mm and 25 mm fascias, there is no need to use a support board. The gutter or eaves are then attached directly to the soffit and fascia. The cladding of your home is also essential for another reason, and that is purely aesthetic. These are vertical boards that are directly under the roof, so they are apparent. Over time, cladding boards tend to become weathered and therefore discolored, and they should be serviced annually, including painting if they are made of wood or just cleaning if they are made of vinyl or metal. During this annual maintenance, the cladding should also be checked for rot or damage to support the gutters or eaves.
I'm thinking of doing the same thing shortly. I have a particular question I would like to ask. Tiny house fashion. What material would you recommend for the roof? And what would be the material selection It's can be easily cleaned? I know it might be a bit complicated, but do you have any suggestions for roofing material? Actually, this is the question I want a clear answer to. Kind regards... :)
 
Top