Recent content by pinpointdan

Changing orings is a pain and I dont see a need to have a gun where I can change lances easily. Are there any guns that use just a brass threaded fitting to attach the lance to the gun?

I've got a craftsman lawn mower my neighbor gave me. It has run fine for 2 years and when I went to start it for the first time this year the starter turned the engine but slowly then that stopped and nothing happened. I thought it was the starter but my father in law helped me figure out that...

We are about to have the ability to run 17gpm! Its going to be awesome, except at places like we were last night when even hooking up at two spigots I think we had 10ish gpm. I have seen mention of people hooking up to hydrants and Im curious how that works.

A new store going up with new concrete seems like a perfect opportunity to get them off to a great start before cars start dripping oil on everything. But how long does concrete need to cure before pressure washing. Seems like if its hard enough for cars to drive on its hard enough for pw but is...

<iframe width="560" height="315" src="//www.youtube.com/embed/3fGxlPWCeHc" frameborder="0" allowfullscreen></iframe> It started pretty quickly but when its cranking there is a sound i dont think is right.

I mix my chems in five gal buckets and use pump sprayer to hit oil spots etc. Im looking for a better way to get from bucket to sprayer.

Weekly here. The client was doing twice a week before but our once a week kills their former twice a week sloppy service.

Car engine, big, quiet. PW engine, small, loud. Has anyone done any extra muffling of their pressure washer to reduce the noise. Ive been curious about this since we got it but now we have a client that is night work and we are getting a lot of their friends. If we could start at 10pm rather...

Before you say it, I know, I need a bigger truck, but until then... I have a 2000 Ranger V6, manual says max trailer weight is ~4000 lb. This is fine because our rig is only 2000-2500 dry. We need a second unit on there though. Im concerned that the tongue weight is going to be limited. Im...

Kiloman Hal gave me some good advice of chems. Our pw downstreams very weak. Pump spraying is ok on places around greas dumps and things but time consuming on large areas. What if I put two injectors on a line and put the hoses in the bucket, will that double the draw?

Does anyone know much about these. Do they pretty much do the same thing? Im trying to research and getting a little lost.

Im thinking it may be the orings i use. It seems to happen after using heat for an extended period and its on smaller nozzles. Is there a filter that I can use on my surface cleaner and are there particular orings that should be used for hot water pw. Viton?

I have destroyed 2 spray bars in a month. Actually one was me one was my partner. one down by a doorstop the second one by a rock, probably. grr

Do you do a broad pretreatment on comm flatwork?