Tricks of the trade?

[want2skydive]

Is there or has someone considered a Tricks of the trade section to share ideas to improve work quality and speed.

 

[Danny Bates]

Is there or has someone considered a Tricks of the trade section to share ideas to improve work quality and speed.

You mean like this one

http://www.propowerwash.com/board/upload/showthread.php?t=13098&highlight=share+trick

 

[want2skydive]

Lol. I've just spent the last hour reading that thread after seeing it in the area of recently commented on threads. Good information but it looks like it hasn't seen much action lately.

 

[Doug Rucker]

Dual Lance Extension

I take an old gun apart and put the small little piece you see in Pic 1 that I am pointing at between my gun and lance (pic2) and it lengthens my wand/lance set up just enough that it helps prevent from bending over when wanding or trimming out concrete and small patios.

 

[Andy Hinson]

I take an old gun apart and put the small little piece you see in Pic 1 that I am pointing at between my gun and lance (pic2) and it lengthens my wand/lance set up just enough that it helps prevent from bending over when wanding or trimming out concrete and small patios.

What are the other parts called? Looks like you added a 90 degree angle.

 

[Doug Rucker]

No other parts. No 90 degree angle either. Just a straight piece of small pipe from the inside of a gun.

Sent from my SPH-M910 using Tapatalk

 

[Andy Hinson]

No other parts. No 90 degree angle either. Just a straight piece of small pipe from the inside of a gun.

Sent from my SPH-M910 using Tapatalk

Gottcha. I thought the part to the right of your hand was part of your wand