Roy Sanders
New member
I noticed this morning that when I cranked up the pressure it was pulsating a little. I cracked open the whip line that I have to bleed the system a little in case I had air in it. The water was barely coming out. I closed the whip line and had no pressure reading on the gauge. Then after a few seconds it would start pulsating again and the pressure gauge started jumping in sync with the pulsating. It would level out and I would have pressure. I once again opened the whip line and I would have pressure for a couple of seconds then just barely come out again. Not sure I need to start at the unloader or the pump. This is on my skid that I use for light power washing and carpet cleaning. 24 horse kohler with a 5cp Cat pump and I believe a blue spring unloader. When pulsating you could hear a clicking noise but could not pinpoint it as it is hard to get into this machine the way it is built. Any advice on maybe a place to start or a method to use.
