My 4gpm hardly moves a 19" bar to really be efficient. Find a used 4gpm and plumb them together and you'll be rocking with a bigger sc.Also if 1 machine goes down you'll still be able to finish and not piss them off.
Call russ at southside equipment, ask for the siamese kit. Bout $100. Pays for itself.I have another machine I do not use. How would I put two together?
Cant have a trapped pressure unloader. Might have to install a new one. Tell him what you've got.
Sent from my LG-H811 using Tapatalk
16I just got approved to do a whole community sidewalks and walkway. I was thinking of purchasing a 36 or a 28 inch surface cleaner, I'm looking for some feedback. I have a 13hp 4000psi 4gmp washer. Any thoughts?
..and bring the heat! cold water dose not clean concrete
haha didn't mean to ruffle any feathers fellas. I have done my do-diligence and have researched this industry for the past year. I have ran side by side comparisons of using my SC with steam and cold water. Which resulted in a clear visual difference for me. Not to mention the time I save on a job site. As I can can clean concrete much quicker with steam, which creates a larger profit margin per job for time worked. Of course the best way to clean mold off houses is with low pressure, cold water, and good chemies. I was only talking about using steam to deep clean concrete with SC.
Actually, cold water does just fine if you know what you are doing...