Greetings guy and gals.
This question is for the people who service their own equipment.
I have an Annovi Reverberi XMV-3G30 pump mated to 9 HP Honda motor.
Well, the pump has decided to break off two of the plunger connecting rods from the crank.
I have not yet decided if I'm going to repair or
replace, but I'm unable to remove the pump from the shaft.
Does anyone know a way to do this. I had the same thing happen
with my GP pumps some years ago so I anti seize them to prevent this.
I just don't remember how we ended up separating them.
Thanks
This question is for the people who service their own equipment.
I have an Annovi Reverberi XMV-3G30 pump mated to 9 HP Honda motor.
Well, the pump has decided to break off two of the plunger connecting rods from the crank.
I have not yet decided if I'm going to repair or
replace, but I'm unable to remove the pump from the shaft.
Does anyone know a way to do this. I had the same thing happen
with my GP pumps some years ago so I anti seize them to prevent this.
I just don't remember how we ended up separating them.
Thanks