Terry Campbell
Member
I'm a Newbie at using Sodium Hydroxide Beads, I have a few Dumpster enclosures to do and they have grease rendering containers in them, some are not to bad, but a couple are real nasty and the cleaner that I have been using does not get it clean enough for me. What is the best way to apply this stuff. I have a down streamer, so I was wondering if I can down stream this or should I buy an X-JET to apply it ? or is there something better or safer to use to get this Grease up off the concrete and block walls and any safety tips would be nice too, I have been reading up on this stuff and want to make sure I do it safely.
I have been using some Landa L-217 and it works good on most of the stuff I use it on, But the real thick grease that has been there forever I can't seem to get it as clean as I want it and this stuff is not cheap either.
Any help would be Appreciated on this subject.
Thanks Terry........
I have been using some Landa L-217 and it works good on most of the stuff I use it on, But the real thick grease that has been there forever I can't seem to get it as clean as I want it and this stuff is not cheap either.
Any help would be Appreciated on this subject.
Thanks Terry........