Freeze season checklist: winterizing your pressure washer pump, hoses and reels

Kris Meyer

Administrator
Staff member
Morning everyone, Kris here. First freezing nights are showing up across a lot of the country, so here's a quick refresher on keeping your rig from cracking a pump or a coil this winter. Freeze damage is the kind of repair nobody budgets for, and as the Mi-T-M / John Deere manual for their cold water units puts it: "FREEZE DAMAGE IS NOT COVERED BY WARRANTY."

The basic routine most manufacturers agree on:
  1. Flush out any chemical/detergent with clean water first.
  2. Shut off the water supply and relieve pressure by squeezing the trigger (pointed somewhere safe) until flow stops.
  3. Disconnect and drain the supply hose, high-pressure hose, gun and wand.
  4. Feed a non-corrosive pump antifreeze / pump saver through the water inlet until it comes out the outlet. Cycle the trigger a few times so it reaches the unloader and other internal parts.
  5. Mix antifreeze for the lowest temperature you expect, per the protection chart on the jug.
  6. Store the unit and accessories somewhere dry and frost-free. On gas units, add fuel stabilizer and run it a couple of minutes so treated fuel gets into the carb.
  7. Before you wash again, flush the antifreeze out completely with clean water and dispose of or save it according to your local rules.

Pro rig notes:
  • Hot water units: CLENA points out the heater should be switched off and the machine cooled before flushing, and the coil needs to be included in the antifreeze circuit.
  • Skids with a buffer tank: drain the tank first or leftover water will dilute your antifreeze. Push the mix through every circuit, including the hose on the reel and any return lines.
  • Trailer parked outside overnight? Even a single cold night can do it. Plan for it before the first frost, not after.
  • If you just drain and run it dry with no antifreeze, be careful: ice chips can form from leftover drops, and starting a unit that isn't fully thawed can cause damage.

Sources if you want the full step-by-step:
John Deere / Mi-T-M cold water pressure washer manual (winterizing section)
CLENA: How to winterise your pressure washer and protect it from frost
STIHL: How to Winterize a Pressure Washer

Always check your own machine's manual first, since procedures vary by model.

What's your winter routine? RV antifreeze, pump saver, heated trailer, or do you just keep working straight through? Anybody learned this one the hard way with a cracked manifold?
 
Back
Top