Rust is one of those stains customers notice the second the rest of the slab comes up clean, so it's worth having a solid process for it. Pressure Washer Insider put together a good breakdown on this (link below), and the main point lines up with what a lot of you already do: oxalic acid is usually the whole answer. It turns the iron into a water-soluble complex so it rinses out of the pores instead of you trying to blast it out.
A few takeaways from their write-up:
Full article: https://pressurewasherinsider.com/blog/cleaning-rust-stains-off-concrete/ (credit to Pressure Washer Insider)
How are you all handling rust? Straight oxalic, a commercial rust remover, or something else? And how do you price it: add-on per stain, or built into the flatwork quote? Any horror stories with fertilizer rust coming back after the first rain?
A few takeaways from their write-up:
- Find the source first. Sprinkler water with iron, fertilizer, steel furniture, rebar. Clean it before you fix the cause and you're doing the job twice.
- Pre-wet the slab. Dry concrete drinks the product down into the pores instead of keeping it on the stain.
- Keep it wet for the dwell (they say 10 to 15 minutes) and re-mist if the edges start drying.
- Nylon brush, never wire. Steel bristles shed into the pores and you get fresh little rust spots a month later.
- Two mild rounds beat one strong one. Less risk of lightening the concrete unevenly.
- Mix to the label. Product strengths vary a lot.
- Gloves and eye protection, and pre-wet plants and grass at the runoff edge.
Full article: https://pressurewasherinsider.com/blog/cleaning-rust-stains-off-concrete/ (credit to Pressure Washer Insider)
How are you all handling rust? Straight oxalic, a commercial rust remover, or something else? And how do you price it: add-on per stain, or built into the flatwork quote? Any horror stories with fertilizer rust coming back after the first rain?