does it have a 12volt burner on it?
What tip size you running mike? If you just using the unloader to get your desired pressure you may not be flowing 8 GPM.I don't think your gonna get 1800 out of the 16 hp. 1500 psi is going to be about it, and you will need a 15 tip(.094).I would put that tip in there and then turn the unloader up to see how much pressure you have and then turn it down till right when the pressure drops a little, and then make sure it's not spiking too much, and run it.Ron,I use the UDOR GKC 30/20S. It is rated for 8gpm @ 3000psi. The pump works fine at lower psi, just adjust the unloader to set the pressure. You w ill never kill that pump working at half its rating, it is a beast. Blaine got me a screaming deal on them through him.Call with any questions, Mike
Do you have any pics of this beast working? I was really interested in the udor set-up but backed off and went with an air driven G57 1-10gpm. I would like something with more vertical reach.
What tip size you running mike? If you just using the unloader to get your desired pressure you may not be flowing 8 GPM.I don't think your gonna get 1800 out of the 16 hp. 1500 psi is going to be about it, and you will need a 15 tip(.094).I would put that tip in there and then turn the unloader up to see how much pressure you have and then turn it down till right when the pressure drops a little, and then make sure it's not spiking too much, and run it.
I run a #15 tip, they flow well. I like them very much. I would use a smaller engine if I could solve the gas tank size dilemma with the 13 hp motors.