tcolborg
New member
So being still new to this I need some help. I picked up a pressure gauge to test what I was getting out of my machine. It is a water dragon skid, 3500psi @ 5.6gpm. I connected it to the high pressure line right before it goes in to the reel. I was getting about 2000psi through 150ft of hose with a 0 5.5gpm nozzle. When I let off the gauge would jump to about 3500. I tried to adjust the unloader, but when doing so the pressure on trigger didn't change. However, the pressure off trigger jumped up to 4500. Not sure if I am missing something on this. I just tightened the nut on top of the spring on unloader.
Am I not doing it correctly?
Sent from my HTC One_M8 using Tapatalk
Am I not doing it correctly?
Sent from my HTC One_M8 using Tapatalk