socalkol
New member
I am looking to hook a 3 way ball valve to my chem injector so that i can just toggle the valve to go from soaping to drawing water/flushing the injector
So the ball valve would hook up to my chem tank, my injector, and my buffer tank. The plan was to put a 1/2" bulkhead near the bottom on the side of my 275G buffer tank then run a 1/2" mpt to 1/4" barb out of it to 1/4" poly tubing to the valve. Will this layout cause any issues considering the size change or the pressure from all the weight of the water tank feeding towards the valve? Should i be putting this bulkhead on the top of my buffer tank instead and running a hose down into the tank?
Thanks
So the ball valve would hook up to my chem tank, my injector, and my buffer tank. The plan was to put a 1/2" bulkhead near the bottom on the side of my 275G buffer tank then run a 1/2" mpt to 1/4" barb out of it to 1/4" poly tubing to the valve. Will this layout cause any issues considering the size change or the pressure from all the weight of the water tank feeding towards the valve? Should i be putting this bulkhead on the top of my buffer tank instead and running a hose down into the tank?
Thanks