Is this a good setup?

C

Carolina Clean

New member
Hey Russ what do you think about this setup. Was think about throwing this on the rig to run a surface cleaner and maybe some soft wash. Can't really find any info on sprak. Are part available for this pump? Suppose to be a 5 gpm pump.

pressure.jpg

pressure4.jpg

pressure3.jpg

pressure2.jpg



Thanks!
 
It will be loud. It is also pretty old. There are parts for the pump. I am pretty sure it is a TS2021, which is the standard for the industry, in my opinion.
 
I would guess it would be worth no more then a couple of hundred dollars, at most. That is if you can verify it is fully operational.
 
Parts are available for the pump and engine. As was previously mentioned, make sure it works as it should. The inlet strainer is crap, and the missing piece of sheet metal on the engine needs to be replaced or the cylinder will overheat. Looks like someone installed a new starter and chucked the sheet metal ducting over his shoulder.
 
If it runs $200 is not a bad price. See if you can get it for $150, it may be a good backup. I would pull the gearbox off the engine though and check the key on the shaft or Scottwash will be right it will be a $200 anchor.
 
You must log in or register to reply here.
Back
Top