I have an Annovi Reverberi XMV-3G30 pump mated to 9 HP Honda motor.
Well, the pump has decided to break off two of the plunger connecting rods from the crank.
I have not yet decided if I'm going to repair or
replace, but I'm unable to remove the pump from the motor shaft.
Do you know a way to do this. I had the same thing happen
with my GP pumps some years ago so I anti seize them to prevent this.
I just don't remember how we ended up separating them.
Thanks
__________________
Uncle Barnaby's
Deck Restoration.
Report this post to a moderator | IP: 64.12.107.34
11-15-2001 12:39 AM
Well, the pump has decided to break off two of the plunger connecting rods from the crank.
I have not yet decided if I'm going to repair or
replace, but I'm unable to remove the pump from the motor shaft.
Do you know a way to do this. I had the same thing happen
with my GP pumps some years ago so I anti seize them to prevent this.
I just don't remember how we ended up separating them.
Thanks
__________________
Uncle Barnaby's
Deck Restoration.
Report this post to a moderator | IP: 64.12.107.34
11-15-2001 12:39 AM