Donte55
New member
So im still fairly new and have been in here reading a lot. I have a few questions that i have not been able to find a straight answer on though.
Im using a 4/4k belt pressure pro with a 20in hammerhead with 25025 tips, and 50ft -150ft of hose.
1.)I cleaned a drive way and sidewalks the other day. When i was rinsing the side walk i noticed a little sand was in the mix of dirty water. It was not like mountains of sand but definitely noticeable. So im assuming i might have taken some of the cream off the sidewalks. When rinsing the driveway there was no noticeable sand in the water.
Some times when i rains where i live i see lots of sand in the street so again not really sure it i took the cream off the sidewalk or not because it came out good from what i can tell. (The pic of the side walk is the "after" pic.)
2.)Once home i looked at the SC and noticed that the tips look to be pretty close to the ground in height, so its possible that could have been why there was sand. It might also explain the noise i would sometimes hear when i would cross the strip of wood in between slabs. Almost like a hitting or chipping sound. So how do you lift the bar on the hammerhead? The instruction that came with it are pretty worthless.
3.) I also notices some teal looking paste coming from the bottom of the swivel. I have only used this SC 4-5 times and not for very long periods either. Im assuming its the factory grease, im just not sure if its normal for grease to leak out like this especially so soon. Also when i spin the bar by hand you can hear it grinding, so i know that i need to grease it.
4.)How often is everyone greasing their surfaces cleaners and with what grease?
I didn't want to make an individual thread for each question so i just put them all in here.
Thanks for all the help
Im using a 4/4k belt pressure pro with a 20in hammerhead with 25025 tips, and 50ft -150ft of hose.
1.)I cleaned a drive way and sidewalks the other day. When i was rinsing the side walk i noticed a little sand was in the mix of dirty water. It was not like mountains of sand but definitely noticeable. So im assuming i might have taken some of the cream off the sidewalks. When rinsing the driveway there was no noticeable sand in the water.
Some times when i rains where i live i see lots of sand in the street so again not really sure it i took the cream off the sidewalk or not because it came out good from what i can tell. (The pic of the side walk is the "after" pic.)
2.)Once home i looked at the SC and noticed that the tips look to be pretty close to the ground in height, so its possible that could have been why there was sand. It might also explain the noise i would sometimes hear when i would cross the strip of wood in between slabs. Almost like a hitting or chipping sound. So how do you lift the bar on the hammerhead? The instruction that came with it are pretty worthless.
3.) I also notices some teal looking paste coming from the bottom of the swivel. I have only used this SC 4-5 times and not for very long periods either. Im assuming its the factory grease, im just not sure if its normal for grease to leak out like this especially so soon. Also when i spin the bar by hand you can hear it grinding, so i know that i need to grease it.
4.)How often is everyone greasing their surfaces cleaners and with what grease?
I didn't want to make an individual thread for each question so i just put them all in here.
Thanks for all the help