MHasterok
New member
Here's a couple pics of recent work I have done. The before conditions were pretty greasy in these areas.
I am still getting lines, sometimes very noticable, from the path I take with the surface cleaner. Here's the process I use: Rinse with wand, spray on degreaser with hand pump sprayer, dwell a few min, run surface cleaner, then rinse with wand. Usually on a 3 ft wide sidewalk, the first run is awesome (I start on the high side so the water always runs down away from what I just cleaned), the second run( middle of sidewalk), then the last on the other side. The middle usually has about a 12" wide path mark that is darker than the two sides. I have tried to go over it again, and it doesn't help or get that middle run much cleaner.
In another post, someone mentioned chlorine to spray down after the fact. I am trying to keep costs down, so I honestly have not tried that yet. I have paid attention to overlapping, which still did not help. Maybe is it because my surface cleaner is 24", and I'm only getting about 5gpm out of my pw at 3000psi?
Anyone else have this issue??? Thanks!
I am still getting lines, sometimes very noticable, from the path I take with the surface cleaner. Here's the process I use: Rinse with wand, spray on degreaser with hand pump sprayer, dwell a few min, run surface cleaner, then rinse with wand. Usually on a 3 ft wide sidewalk, the first run is awesome (I start on the high side so the water always runs down away from what I just cleaned), the second run( middle of sidewalk), then the last on the other side. The middle usually has about a 12" wide path mark that is darker than the two sides. I have tried to go over it again, and it doesn't help or get that middle run much cleaner.
In another post, someone mentioned chlorine to spray down after the fact. I am trying to keep costs down, so I honestly have not tried that yet. I have paid attention to overlapping, which still did not help. Maybe is it because my surface cleaner is 24", and I'm only getting about 5gpm out of my pw at 3000psi?
Anyone else have this issue??? Thanks!